Company News
Research and development of rotary joints, not of metal
Rotary joint manufacturer worldwide are all made of metal material, can use stainless steel materials, with copper, using carbon steel, cast iron, etc., but did not use nonmetallic material。
people may think，what material it would use instaed of hardware？As technology hindley company has been with the German BMW have close technical exchanges hardwares。Hindney alsi research and development of nonmetal materials to swivel will replace metal rotary joint，This new type of polymer material
Known as the carbon crystal compounds， The characteristics of this compound is primarily abrasion resistance quality light not rust acid and alkali corrosion resistance。
Non-metallic rotary joint used on electric equipment and don't have to consider
To leak and cause unnecessary accidents, while metal swivel joint disposal of the insulation, rotary joints in many cases are high temperature medium, and metal rotary joint
。This will seriously affect the service life of the joints and concentricity，so can increase the internal temperature, resulting in seal scrapped due to high temperature
，Resulting in rotary joints with leaking problem
， it is a high temperature and corrosive medium, will not predictable consequences。And nonmetallic material rotary joint can well solve the problem of customers worry. First of all not, not of metal
Not endothermic nature of metal, and metal materials heat slowly, leading to joint temperature is too high, and non-metallic has good heat dissipation function, so will not giving the inner temperature of the rotating joint
Higher degrees, the heavier weight metal materials, the basic principle of the simplest is known to all.
The more attractive the heavier weight of the thing, the earth, it will affect the concentricity rotary joint
。
Its own weight will increase their gravity down, no matter how sophisticated processing, and joint will have a certain influence, and nonmetallic material quality is very light, downward gravitational pull than metal
Material joint, much smaller, so can guarantee complete concentric, prolong the service life
。Non-metallic rotary joint quality is light, again in the link equipment, need not consider equipment mounted
Whether the shaft afford the part weight, in general, the heavier weight of the rotating joint, the greater the volume, speed is much slower, but also improve the need of horse power
A lot of, need to more power at the same time, and non-metallic rotary joint, large volume, weight is light, in the case of the motor power is low, can balance rotate at a high speed.
From the economic
Ways, reduces the power consumption for the factory, to the customer greatly reduced the investment into this, because the hollow axle load force is reduced, the bearing pressure decreases, and also can make the rotary joint acceleration
Operation, to avoid the heavy influence on bearing, axis of gravity from the principle of friction, the seal is non-metal material, and the axis of rotation is the metal material, metal and nonmetal
Different material qualitative touch each other, mutual friction, seal is very not wear resistance. So is the current global rotary joint using leakage occurs when an important factor, rather than gold
Belongs to the contact friction material and non-metallic materials, has a certain molecular repulsive force, so you want to stick together tightly between two pieces of glass, not only ensure complete sealing, also reduced the friction
And prolong the service life of the seal.
Hidney From all parts of the rotating joint research and over the years the use of customer feedback, invested heavily to develop new materials
Connector, the purpose is to will swivel ascend to a height, make the performance more reliable, more perfect, more suitable for the future needs of society, in the near future will be
Have a better product.
previous posts : In 2008 our company to seal supplier for further quality assessmentnext: China's recent machinery development reviews
